Issue: On Palo43-R2750 boards, the ground signal of the reset button is not connected to the board GND.
Update on August 3rd 2010:
Resolution for existing Palo43 expansion boards:
1. Solder a jumper wire from the right pad of C27 to the upper right corner pad of the Reset push button. See picture below.
2. Dab a small amount of glue where the wire is soldered and in the middle of the wire so that the wire will stay firmly in place.
Resolution for future Palo43 expansion boards:
Palo43-R2909, currently in manufacturing, is planned to resolve this known issue.
